Gas Hot Water Repairs & Replacement in Lane Cove NSW

Every gas hot water installation we complete is finished with a compliance certificate, as Australian Standards require for both natural gas and LPG work. The same licensed team handles emergency repairs, pilot and ignition faults, thermocouple and gas valve replacement, leaking cylinders and TPR or tempering valve replacement. Annual servicing covers the sacrificial anode, burner and TPR valve, and we install new storage and continuous flow units with any gas line or flue upgrade needed.

An honest timeframe is part of the service, so if the gasfitter cannot reach you until later in the day or the following morning you will hear that straight away rather than wait by the phone. Either way a no hot water fault is placed ahead of routine work and after-hours cover is there for the worst cases.

If you are in one of the outer suburbs and wondering whether we will make the trip, the answer is almost always a quick one. Those areas sit inside our regular service run, so repairs and replacements are no trouble.

What you pay is shaped by the type and size of the new system and how different it is from the old one. A direct swap with the same connections is the quickest install, while moving from storage to continuous flow or increasing capacity brings in extra gas and flue work. LPG supply, access and the cost of removing the old cylinder round it out. You get a free written quote first, with no obligation.

Never go beyond the relighting steps printed on the unit. Adjusting the pilot flame, cleaning the pilot jet or working on the gas valve is gasfitting work that requires a licence, and getting it wrong creates a real hazard. Relight once as instructed, and if the pilot will not stay lit, call a licensed gasfitter.

Never let anyone work on your gas supply without seeing proof they are licensed, no matter how experienced they claim to be. Our gasfitters all hold current licences and the business is insured, so that proof is easy to provide. The compliance certificate issued on completion is your lasting confirmation.

Say your pilot light has started going out and the unit is less than about ten years old with no other complaints. In most cases that is a thermocouple or a dirty pilot jet, both of which are quick to sort out, and replacing the whole system for a fault like this makes no sense. We would repair it, check the flue and burner while we are there, and leave you with a unit that has plenty of life left.

Plan your hot water use around the swap. Have morning showers before the installer arrives, because the water is off while the old cylinder drains and the new one is connected. For a standard replacement that gap is only a few hours, and the system is tested and heating before the gasfitter leaves.

Having the burner, valves and flue checked by a licensed gasfitter means you are not relying on luck to keep hot water flowing through winter. The service covers a clean of the burner, tests of gas pressure and the thermocouple or ignition, a flue and draught check, a TPR valve test, a tempering valve set to a safe 50 degrees Celsius, an anode check, a sediment flush or descale, and a leak and carbon monoxide test. We tell you what is wearing out and leave the decision with you.

Installing a new gas hot water system should not leave you anxious about what happens if it fails. Between the manufacturer’s warranty on the unit and our guarantee on the workmanship, every part of the job is covered by someone accountable. We would rather you call us with a small concern early than worry about it in silence.

A dribble of water from the TPR valve or a damp patch under the cylinder can look alarming but is usually a worn valve rather than a failed tank. The valve is a safety device that is meant to release a little water now and then, and a gasfitter can replace it quickly. Only a steady leak from the body of the cylinder itself points to the end of the unit.

If your current storage cylinder has served you well, replacing it with another is a perfectly good decision and often the quickest. If you have outgrown it or want to free up the space it occupies, a continuous flow unit mounted outside may be the better move, provided the gas supply and water pressure measure up. We assess both paths honestly and quote whichever you prefer.